1. The four-wire LED strip has four wires, three rows of lights (note that it is not four rows of lights~~), each row of 1 meter 24 lights, 24*3=72. Because the power of each lamp bead is 0.05W, the power of the 72-bead LED strip is: 72*0.05=3.6W.
2. The width of the four-wire LED lights is about 22mm, the thickness is about 8mm, and the weight is about 0.25kg/m (4 meters per kilogram). Each LED strip must be equipped with a special plug (plug with a transformer); it must be connected Remove the transparent plastic cover, and then close the test lamp. It is impossible to connect directly with the cover, so it is easy to short-circuit!
3. There is a "reaming cut" mark for every meter, and it can only be cut when the mark is cut. Wrong cutting or cutting will cause one meter to lose light! Some will miss the mark because of the mark. Fortunately, look at the position of the mark carefully before cutting it, and cut it at the place where the center is not connected. You can tell if you look carefully.
4. When the LED lamp belt is installed, it is usually placed in the lamp trough and just straightened, or it can be fixed with a string or thin iron wire. If external or vertical installation is required, clips and tail plugs need to be purchased separately. The original clip is fully transparent. Fortunately, after installation, put waterproof glass glue on the tail plug and plug, so that the waterproof function is better.
